Your water heater is one pretty used and more expensive appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and energy costs.
Regular flushing of your water heater is considered the single most important step you consider to prolong its service life and even save energy. A duration of time, sediments enhance in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most involving the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double daily life of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s weather. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, which will help should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. You can then connect a garden hose to the drain valve located at the base of the space heater. Open the drain and allow it to play until all from the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until water flows out quietly. This will allow air to vent off of the heater and the water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX